Width TolerancesUp to 200mm in
slitted sizes with tolerance of
± 0.50mm
Above 200mm will be supplied in as rolled
condition with mill edges & fish tail but without
leader end as per following tolerances:
Thickness
in mm |
Tolerance in mm |
2.10
& above |
-0.00,+ 6.00 |
Below 2.00 |
-0.00,+ 7.00 |
Thickness Tolerances
Thickness
in mm |
Tolerance in mm |
2.50
& above |
± 0.05 |
2.10 to 2.45 |
±
0.06 |
1.80 to 2.00 |
±
0.07 |
Below 1.80 |
±
0.10 |
Camber
» As per BIS standard
Coil condition
»The edges shall be mill edges as agreed with the buyer
»In case of mill edge coils, the coil defects like burning & cracks will be within 5 mm from the
edge on either side of the coil.
»The coils may be without tongue but with fish tail
»The coils will be supplied in as-rolled condition without any skin passing, oiling, annealing & normalising etc. unless otherwise specified by the purchaser.
Coil ID
» 510 m |
